Printable View
I was curious typically how many passes should you use on an 8k of the norton stone? I some some say depends on the steel, the razor, the brand and whatever. Well I have a 5/8 Dovo Solingen Perlex that is stainless steel hollow ground. I just want a range because I haven't got it to shave good yet and I hear some people say you might have to use up to 100 passes, but I was wondering if that's considered overhoning? I just want a range of how many passes before it might be able to pass the hht?
You should never need to do 100 passes on an 8K, IN MY OPINION. I know there are some here who do multiples of 100 and I think that just misses the point of the hone. You need to set the bevel with a coarser stone that removes metal to properly set the angle of the blade. A 4K can do it slowly, a 1K will do it faster. If you start with a 1K, you should follow with the 4K to remove a little more metal to primarily smooth out the scratches of the 1K. 20 to 30 passes is usually sufficient on the 4K. After that, the 8K is used to smooth out, or polish, the scratches of the 4K. It shouldn't take more than 20 or at most, 30 strokes to accomplish that. I usually only do 10 to 15 on the 8K.
My point is that the 8K is a polisher. Once its done the job, stop. The 8K will never need 100 strokes to do its job.
If you haven't done so, read up on honing in the newbie sticky or in the Wiki.
Good luck!
Right on. At this grit level, you're just polishing (IE removingQuote:
My point is that the 8K is a polisher. Once its done the job, stop. The 8K will never need 100 strokes to do its job.
striations from the previous stone), not sharpening. Since the
8k is a fast cutter to boot, you're looking at 10-15 strokes at
most.
- Scott