Why do certain brushes eat more lather?

When it comes to badger, is there a rule of thumb as to why one will eat the latter more than another?

I would think density has a lot to do it with it?

Have a beautiful custom made brush with a VS 2 band in it and for the life of me cannot get it to give up the lather. I know its in there because I can squeeze it out, but cannot get it onto my face when face lathering.
Have tried the dry method of warming it in water then squeezing the water out, loading the snot out of it, nothing seems to do it.
An using only creams.
C&F and Baum

Advice?

Want to get another custom made but not sure now what knot to use now

I've found that if your lather is to thick, larger "fluffy" type brushes hold lather much more.
Have you tried to use a bit more water? That helped me with my Whaler brush from Blackship Grooming. That thing is huge, and can hold enough fro 4 passes

I've found the same thing with boar brushes. I use an inexpensive Omega as my daily brush. I was gifted a well broken in SOC. The first time I used it I put the normal amount of soap on my face (I use shave sticks) tried to make proto lather with the SOC...nothing!! I applied another layer of soap....nothing again!! More soap and at this point I could see a tiny amount of lather, but not yet enough to use!!! I put down the SOC, grabbed my go to brush and never looked back. PIFed the SOC at the earliest convenience.

My inexpensive Omega boar is the most soap miserly brush that I've ever used.

its the nature of the beast, a good dense knot is going to hold it better, a cheap thin knot will get it all over the place,, but if its not getting out then add a little more water and try some painting strokes to finish getting it on your face, cause if your really scrubbing it hard itll just go deeper, I tend to not soak my brush and just the tips, so mine stay pretty much on the end of the bristles. I,ll put up with holding some lather, over a cheap knot , also theres no rule says you cant squeeze out the lather to the end to get it Tc

It's a combination of things. The density and size of the brush as well as type of hair and the soap itself and how well you load it and the amount of water you add.

Can't say why some brushes are lather hogs and others are not. I always thought a dense knot was likely the cause.

If you are using only creams, loading the snot out of it is not needed. Loading the snot out of it is usually for hard soap pucks. With creams an amount the size of a kidney bean should be more than enough for a 3 pass shave with virtually any brush.

Bob

some of the bigger Badgers have bigger appetites! Tc

Quote:

---

Originally Posted by thebigspendur

It's a combination of things. The density and size of the brush as well as type of hair and the soap itself and how well you load it and the amount of water you add.

---

To add to the information above, probably, the most important thing to do is to use more 'forceful' paint-brush strokes when face-lathering to extract the lather from the knot/brush.
Good luck.

Quote:

---

Originally Posted by celestino

To add to the information above, probably, the most important thing to do is to use more 'forceful' paint-brush strokes when face-lathering to extract the lather from the knot/brush.
Good luck.

---

Like so??


Attachment 269325

Or more like this?



Attachment 269326

It's a 50/50, but I'm sure either way will give you a nice lather fully applied :rofl2:

Now THIS guy seems to have lathering down to a science!

Attachment 269358

Maybe, not quite as forceful. :)