I got a question about how i bond the wood handle to the imitation horn knotholder. I figure i would post it here.
I pre drilled a hole abit smaler then the A4 woodscrew and countersink it. I then epoxy glued both the hole/screw and the surfaces betwin the two pieces. I did this because i have bad experiance with brushes that
only has the two surfaces glued, it pretty much takes one hit against something solid and the glue will fail in the joint. Same with unstabilized wood/horn that can move around. Not saying it will happen to yours but this is my experiance and if i can make something more solid, i try :)