18 Attachment(s)
A couple of C-Mon Brushes reborn
No threads here for 3 months? Let's get some brushes going, guys!:D
Paid a premium for a couple of NOS C-Mon boar Brushes a few years ago, sold from Ellicotteville, NY in the 40's/50's when the partnership of Burrell and Monkhouse was in full-swing. I suspect these were produced by Rubberset for obvious reasons and the boxes proclaim they were distributed from Ellicotteville by the infamous Peter J. Michaels who seems to be an enigma. (Personally, I think Mr Monkhouse WAS PJM? A theory!)
Anyhoo, the original shellac/lacquer finish was peeling from the handles and I set about sanding it off in order to put some new clear on.
Attachment 310538
A thought came to mind that I could do something custom with them. Nothing wrong with a good boar knot, but badger seems to be the way most like them, so measured the top bakelite barrels and ordered-up some 22mm 2-band 'Mag-Knots' from Maggards. A few bucks more than from China and a hell of a lot faster to receive. Nice knots!..
Attachment 310539
Taped-up the bristles and clamped them in a vise far away from the barrels. (have broken one before clamping too close!)
The Holy hacksaw dispatched the top and a Forstner bit, 3/4, slowly ate through the bottom leaving the outer ring which was gently removed with a dremel-drum.. These bakelite tops are fragile, I tell ya!
Attachment 310540Attachment 310541Attachment 310542
Attachment 310543
Now to dig a bit deeper as there is never enough to properly set a badger knot in these old handles, IMO.
Back to the Forstner bit and about 3/16 deeper, making certain to leave enough material at the transition.
Attachment 310544
Dremel-drum that outward and smooth things out. Enough room now for some adjustability to set the knots like I want to and still have room for adhesive Goop at the bottom.
Attachment 310545Attachment 310546
I never buy paint unless I have to...Some red laquer and black engine enamel off the shelf.
Some pinstripe tape at the transition and taped to some PCV for handling purposes. About 6 coats with fine steel-wool in between. Lots of drying time afterwards.
Attachment 310547Attachment 310548Attachment 310549
Finally, about 3 coats of some clear wheel-coating off the shelf and more drying-time, Found some nice square-cut o-rings for the handle transition for looks and to keep pesky lather out. Ready to set the knots.
Attachment 310550
Smear some Goop in the bottom and a healthy dollop on top of the plug and up/in. Get them where I want them.
Hang up for a few days. (Lazy AND Patient. That's ME!)
Attachment 310554Attachment 310555Attachment 310556
Turned-up fine with me. One-of-a kind brushes! :D
Attachment 310559Attachment 310560
