I had a pair of these Engstrom "made with wire rope" razors a few years ago which I scaled in vintage ivory. Sadly, I had to sell them and they wound up with a good friend. A good thing! :D The one I missed most was a super-smiling 4/8.
I missed shaving with that!
I finally procured another Ran-tan-karus smiler, 13/16+ in width, and set out to scale the blade in ivory. But I remembered I had an old set of scales with the devil logo left over from that pair I sold and dug them out. I was able to use the front scale and get this thing going nicely in Bakelite. Digging this thing. Hope you all like it! :D
Attachment 173026
The rear scale was broken, so I needed to match a rear scale.
Attachment 173027
Found a donor, 1/2 hole off, so I filed the pin holes inward on one scale and outward on the other, sized some of Babur's silver collars to the bottom and bolted it together there, filed the top even and sized some collars for that end.
Attachment 173028 Attachment 173029
Bolted all together and matched the scale halves as I described in this thread! http://straightrazorpalace.com/works...le-halves.html
Attachment 173030
Unbolted as sanding the contours and removed/indexed each collar for it's position in order to finish the scales
Attachment 173031
Next I dealt with the logo on the front scale. It IS a RED Devil, not a black devil, but all attempts to get a good red on the bakelite was not satisfactory. I practiced on the old, broken scale half till I hit on this. Rub-n-Buff silver, allowed to dry, colored by a liquid Sharpie, applied with pointed q-tips. It can be seen and looks good to me!
Attachment 173032
Ready to assemble now! Lead wedge original to the front scale.
Attachment 173033