Originally Posted by
celticcrusader
There is another fix and it can look really good if you are careful and approach the job with care and attention, look for a piece of wood that's a very similar colour to to burl where you drilled the holes out, now cut a few very thin section from this wood with a chisel or penknife and sand it down so it's like a 1/16 needle but obviously getting thicker as it travels up the shaft, now punch out a very small hole in a piece of masking tape and cover the both sides of the scales leaving both holes exposed, now put super glue on the little wooden pegs you've made and push them tightly into the pivot holes leave dry and cut flush and clean them up.