JR Torrey ARMY razor with camo micarta scales and 9mm pins
I wanted to try to make my own micarta so I decided to take a break from making steampunk scales and give this idea a try.
I recently acquired a nice JR Torrey ARMY razor (I think issued during WWI) and I wanted to update the plain black scales.
I took a pair of British bdu's and cut 6 pieces of fabric and glued them with epoxy resin and let them sit clamped overnight. Homemade micarta is fuzzy when sanded so I put 10 coats of ca (or so) over these.
I wanted to try to use 9mm brass cases to surround the pins. This turned out to be quite a bit harder to pull off than I expected. After cutting the cases with a dremel I countersunk them into the micarta. However i needed 5 #0 washers on each pin in order to bring them to the proper heigth. I had to try this 2 different times and I"m still not very happy with the result of my pinning. I flattened them too much :( I still have a long way to go...
The spacer is cocobolo hardwood (used in many pistol grips) sandwiched between 2 pieces of thin brass.
http://www.antiquemilitaryshooter.co...rmy1_small.jpg
http://www.antiquemilitaryshooter.co...rmy8_small.jpg
http://www.antiquemilitaryshooter.co...rmy4_small.jpg
http://www.antiquemilitaryshooter.co...rmy5_small.jpg
http://www.antiquemilitaryshooter.co...rmy6_small.jpg
http://www.antiquemilitaryshooter.co...rmy7_small.jpg