I dug this worn,broken, ugly Case razor out of the drawer and after a little contemplation and a quick sanity check I started in on it.
Reprofiled the nose into a full round, ground the edge back by hand on a selection of stones. Polished and cleaned up the surfaces but did not want to remove the minor pitting and patina marks. I stropped the edge and it is darn sharp, but not shave ready.
Next came the scales, I got a block of amboyna burl from my buddy a while back and it was just what it needed. I cut a couple of small scale blanks and drew my pattern design on. I tacked them together with a couple drops of CA and profiled then drilled. I made the wedge from walrus ivory and the pins are hand hammered and domed 1/16" brass. Finish is CA and hand rubbed.
Before...
http://i49.photobucket.com/albums/f2...8-06095127.jpg
http://i49.photobucket.com/albums/f2...8-06095227.jpg
During...
http://i49.photobucket.com/albums/f2...8-06125512.jpg
http://i49.photobucket.com/albums/f2...8-06180821.jpg
http://i49.photobucket.com/albums/f2...8-06164948.jpg
After...
http://i49.photobucket.com/albums/f2...8-07090644.jpg
http://i49.photobucket.com/albums/f2...8-07090737.jpg
Let me know what you think, good or not so good.
-Xander