Had to do a little smithwork and stretch out my throttle linkage due to the new carbs.
Attachment 341294
Didn’t lose much thickness since I worked the sides into the middle as I drew, drawd it out by almost 2”
Attachment 341295
Twill be mounted lower of course but will connect, via linkage to this side of the rear carb and drive both.
Attachment 341296
Should work a treat, needed it narrower to allow a full 90’ arc through the firewall to ensure full throttle response. And by making the arm longer, I gained increased vertical throw in relation to the throttle shaft rotation! That means less peddle travel basically or a more responsive peddle.
And before I can close up the boot and rear of the interior I need to cut in the new storage I created under the floor.
Attachment 341297
Ends up 23x18” and 2” deep. Enough for the tonneau I hope.
Will keep the back nice and clean to look at, once carpeted. Still need hinges, hatch lock, and repaint etc..
:tu