Smoothing surface of finishing hone question

I have 2 finishing hones right now an Oozuku jnat and an extremely hard coticule. I recently lapped the coticule, it was giving really good results but I noticed it wasn't completely flat. I lapped the coticule with a somewhat worn out dmt 325 plate and now I was wanting to smooth out the surface some. To smooth out the surface of the coticule I was thinking of either using a 5k/8k naniwa ss, my midstone jnat,or my thuri bout. I have seen some post where people warn that particles can get lodged into other stone and what not so thought I would ask you guys. Could use 2k sandpaper but I would rather not, just looking for info on using other stones.

Thanks for any help

edit: I do have slurry stone for it, I know it will smooth it out as well over time

I'd say the slurry stone under running water. From what I've read and tried this worked the best for me.


Enjoy the day,
Benson

Quote:

---

Originally Posted by BWH1980

I'd say the slurry stone under running water. From what I've read and tried this worked the best for me.


Enjoy the day,
Benson

---

+1 to this, but I get better results going to 600 grit then using the slurry stone under water. I get a better surface keeping the stones vertical, when using the slurry stone under running water.

In my experience this is one of those things that is very stone-dependent. You'll need to try a few different ways of smoothing your own individual stones to see what works best. Some stones are better with no smoothing, some need a rub stone smoothing, some need high grit wet/dry and some need burnishing with hard steel.

I have a tiny ark that I after use for smoothing and slurry generation on hard stones.

dinnermint is correct on the vertical, I forgot. I haven't tried the 600, but will on my next lapping.


Enjoy the day,
Benson

Quote:

---

Originally Posted by eKretz

In my experience this is one of those things that is very stone-dependent. You'll need to try a few different ways of smoothing your own individual stones to see what works best. Some stones are better with no smoothing, some need a rub stone smoothing, some need high grit wet/dry and some need burnishing with hard steel.

---

Underlined is what I was inclined to suggest. You could smooth the surface with the shank of a large screwdriver. Just don't add a lot of pressure. Another alternative would be to simply hone with it, which will smooth the stone as well.

Lapping paper on a kitchen worktop is what I use.
Sounds like I sold you the one that wasn't lapped yet. :(

Couldn't be happier with the coticule you sold me. I just used the slurry stone to smooth it out and it seems to have done the trick. Will do some honing later but I am sure it is going to be very nice shave