Results 11 to 13 of 13
Thread: Question about future honing
-
02-12-2010, 12:47 AM #11
Grits on barber hones are unknown, but I would guess they are approximately 10-12k-ish (at least the ones I've played with)
-
02-12-2010, 01:38 AM #12
Not all barber hones same. they will differ each other.
in your case try to get.
King midas
franz swaty
Keen cutter
duble duck
velvet edge
Lakeside
Cmon
Any of them will do the job. Prices will go up Example most expensive one will be in the list is C mon 2 sided.
hope this helps.
There are a lot more out there but if you can get any of them you should be fine.
-
02-12-2010, 02:38 AM #13
Also look at balsa hones.
A pair of balsa hones one with 1.0 or 2.0 micron diamond
and another with CrOx can be a cost effective
solution for some, especially if you make your own.