Printable View
OK, I have a set of Naniwa hones (1k, 5k, 8k, 12k) and I'm learning to hone. I don't plan on becoming a honing service I just want to be able to hone my razors and the razors I restore.
So here's the questions...
In doing restorations is there I time where I would need a hone below 1k grit for any reason?
Is there a grit that I must add in my current collection for personal honing use?
I have a 325 diamond plate that I use for lapping. On 1 occasion I used it to help take out a severe chip in a wedge. I also have a 600 grit diamond plate and have used it to assist in cleaning up some seriously chipped razors a very few times. Other than that I have the same basic grits as you do and I get along fine. OTOH, I don't buy chipped razors anymore, nor do I do restorations. I know some of the guys that do have a bevy of lower grits to take care of that sort of work. Wouldn't hurt to have one or two on the low end if you anticipate running into that sort of job, but otherwise I'd say you've got what you need.
Jimmy said it all +1
My DMT 325 serves double and triple duty sometimes :)
I have a DMT 325 for lapping my stones and actually it was worth every penny considering the time and effort I save over the sandpaper on granite method I was using before. I was afraid to attempt actually putting a razor to the DMT over the fear of potential damage, that and I have yet to attempt to hone a razor in such poor condition until I actually get some honing skill, you know, baby steps and all.
When going to a low grit like that I always use a layer of tape. Even if I'm not going to use it at the later stages. Just in case you didn't think of it. Also check the wear on the tape every so often and replace it with a new piece if it is wearing through.
Congrats on a great set-up. I would consider a Nani 2 or 3K. I love my 2K.
I agree, it looks like you have a gap between 1K and 5K. With 2 or 3K your honing progression will be more smooth.Quote:
Originally Posted by pcb01