different coticule bevel setting slurries for different grinds of razor?

I was having a bit of a problem with a full hollow razor on the coticule just after successfully honing a quarter hollow sheffield with the same hone without any bother but I could only manage a very rough bevel.

what I noticed was that the bevel setting slurry I used was too thick for the full hollow - even though it was the same slurry (approx.) that I used to set the sheffield razor - so what I did was went straight to the coticule under the tap and after 2 sets of 30 with pressure (both sides) on water it created a very smooth clean bevel on the full hollow.

I was wondering if you guys noticed the same thing with your coticules?

kind regards
Alex

Hi Alex,
I don't vary the slurry thickness according to the type of razor (eg quarter or full hollow ground). The less hollow-ground blades often have a wider bevel so they often need more time and attention to get the bevel fully set. So, sometimes I refresh the slurry at the beginning a couple of times before I start diluting to ensure the bevel is fully set.

But in general I try to not getting the slurry too thick and rather refresh or take a bit more time.

Cheers
Jörg

Quote:

---

Originally Posted by jollo74

Hi Alex,
I don't vary the slurry thickness according to the type of razor (eg quarter or full hollow ground). The less hollow-ground blades often have a wider bevel so they often need more time and attention to get the bevel fully set. So, sometimes I refresh the slurry at the beginning a couple of times before I start diluting to ensure the bevel is fully set.

But in general I try to not getting the slurry too thick and rather refresh or take a bit more time.

Cheers
Jörg

---

I refresh my slurries as well. the dressante coticule slurry I have is very sticky, I could run the razor under the tap for 10 minutes without removing all the slurry from the edge so I have to constantly wipe the razor after every slurry, same with the coticule.

I've tried to set the bevel 3 more times on this razor and after 5 minutes trying to set a bevel on a milky slurry it doesn't set but a very thin 2% slurry is where it starts to create a smooth bevel in around 3 minutes (dulled on glass) with a near full hollow razor.

It might be that thinner razors sharpen better from smaller particles in a thinner slurry (I'm assuming bigger particles are more common in thicker slurries) but the dressante is performing very consistently now since I've started using thinner slurries for thinner straights.

kind regards
Alex