-
4 Attachment(s)
DIY 5$ sink bridge
A piece of cedar (1"x6"x5'): 3.5$
6 stainless screws: 1.5$
5' was the shortest I could find at the hardware store, so I made two bridges and even got a leftover piece that I might use to make a jNat base. I made the first bridge with white Lepage glue as a prototype and I ended up using it as a makeshift work bench to drill holes for the second one, which I made with screws. Pictures below are of the latter.
To figure out the overall length, I took the interior dimension of the sink and added about 2 inches (1 at each end). Then I cut 3x 1" wide pieces for the foots and the stopper. I pre-drilled the holes to avoid any eventual splitting (this wood is pretty soft, but I don't know how it will react over time with the wet/dry cycles), and I drilled a wider hole on top to have the screws recessed. The only thing missing in the pictures are grooves to send the runoff water into the sink.
Attachment 197561
Attachment 197562
Attachment 197563
Attachment 197564
Cheers.
-
Nice ,,,,,,,,,,,,,,,,:tu
-
beautyfull , it is multyfunctional you can use it when washing vegetables or dishes .You can use it as cuting board for some aplications .
-
That looks nice, you really don’t need the stop, a piece of rubber drawer liner the size of a stone will hold the stone just fine and can be rinsed and dried when finished.
A 1/8 to ¼ in saw kerf will keep the water from running off the ends. I used a pine board sprayed with clear lacquer for years.