I came across a couple of references to sealing Atoma diamond plates (to prevent rust?). Is this recommended?
Printable View
I came across a couple of references to sealing Atoma diamond plates (to prevent rust?). Is this recommended?
I sealed my first one, by recommendation, and it still rusted a bit on the sides. I did not seal the others I got later and they are just fine.
I thought the plate was made from aluminium?
See http://straightrazorpalace.com/honin...ml#post1639334 and http://straightrazorpalace.com/honin...e-w-epoxy.htmlQuote:
Originally Posted by edhewitt
Onimaru55 says:
Quote:
The base is aluminium. The diamonds are bonded to a thin steel plate which is secured to the base by 3 strips of double sided tape.
I haven't sealed any of my diamond plates, Atoma or DMT ......... the rust gives them character ........... :rolleyes:
I'd rather not have to muck about with sealing it, but was just wondering what was best longterm.Quote:
Originally Posted by JimmyHAD
This thread is the first I've heard of it. Truth be told a couple of my DMTs (got 4 of them) have rust on the corner going up into the diamonds a wee bit. Annoyed me when I first noticed it, but I haven't done anything about it, and it doesn't seem to be getting worse after a couple of years.Quote:
Originally Posted by benhunt
Originally, there was a chance that if enough rust builds between plate & abrasive strip it may bow & not be flat. It's really hard to guess how long it would take & even if it is an issue for one's local humidity levels but if Tsuboman has not changed the build its really easy to spend a few minutes & caulk up the sides. I have one atm that is not sealed . Let you know in a few years if it warps :p
What do you use on the sides?Quote:
Originally Posted by onimaru55
I've used any number of glues & sealents. Just need something that will adhere to smooth aluminium. 5 min epoxy is always a safe bet if a bit messy. Building glues in a small tube are good if waterproof & require no mixing & have a nozzle for application.
I didn't bother sealing any of my Atoma plates and none have rusted. I don't do anything special after using them other than giving them a few vigorous shakes to get rid of any large water droplets then drying the outside surfaces with a towel. The DMT plates are very easy to de-rust - the rust is usually just steel removed from knives or razors rusting on the surface of the nickel plate. A good scrub with some Bar Keeper's Friend cleanser will clean that right up. I usually sprinkle the cleanser on and use a sponge soaked with hot water to make a paste of the cleanser and spread it around the plate, allowing it to soak for a few minutes then scrub it a bit and rinse. Result is a nearly new looking plate.