I was just giving a simple test to discern chip or burr.
Of course, the swipe on glass pushes the burr to the side making it accessible to the next stone where it is quickly removed.
Wasn't suggesting he stop honing at that point :)
Printable View
"I shaved with this razor yesterday morning and have to say it was amazing. Usually after working on a razor I'm like 'Yep, 90% there, close!' This edge is there."
As I ground that 'there' edge into oblivion today the irony was not lost on me. With the now significantly more narrow blade I'm struggling to get the bevels to meet with 2 layers of tape.
I'll have to start a new thread ' Tape, tape and more tape!'
The edge does look much better now.
That old edge really did shave nicely.....
Too funny.
Tape Tape & More Tape,,, Yep Just Ask Us "Inside Joke" We Americans Love Our Tape,,, When In Doubt Put A Piece Of Tape On It!!!!!!!!!!!!!!!!!!!!!!!!!Ha!!!!!!!!!!!!Ty
Thought I'd update this thread with the latest on the Engels. I did straighten the edge. It was surprisingly difficult by hand against the side of a Norton crystolon; probably twenty minutes. I learned about steel splinters. To get the edge straight I had to match it up with the toe as that was the narrowest point. When done it rested flush on my hone. The entire bevel was gone at this point.
I used the Washita to start the bevel set initially with one layer of tape and that only got me so far. Then I went to two layers and changed to the soft arkie as I think it just cuts better than the washita. Per a hint from Steel, I left the slight slurry on the soft created by the light refreshing with the fine side of the crystolon and the stone really cuts but I just couldn't get the blade to catch my thumb pad. I learned to use my thumb pad during this endeavor as I ran it against the entire range of sharp. But it still wasn't there. Three layers and it felt like it was set.
Attachment 253614
Have to say it is a much better edge. Havn't shaved with it yet but it was passing the hanging hair test with flying colors.
Attachment 253615
It was a great learning experience. There's no active rust but there is pitting and I'll need to be diligent.
Attachment 253616
Can't wait to give it a shave. I had to run that spike into the side to the hone box to kill it a bit. Wicked.
Thanks everyone!