Need advice about a chip in edge
Just got my razor back from honing and managed to ding it on the sink within 2 weeks. :mad:
1 slight chip and 1 very small chip on the edge. I'd say about 1/2 the width of the edge's bevel for the larger chip. Not sure how I should proceed to hone hone out the chip with my current stone setup.
DMT 8C 325 grit
3m 2k wet dry sandpaper
Norton 4/8k
Chinese 12k
Can I get the chip out with the norton 4k or will it take forever? I tried setting a bevel on a crappy razor with the DMT 8C and wound up screwing it up, so kind of afraid of the DMT.
So which should I use to take out the chip? I should tape the spine until the chip is out correct?