Scary sharp

I am new here and just ordered a couple razors off eBay. They both looked decent from the descriptions. When they get here, I'll post more info.

My question is, has anyone ever used the so called 'scary sharp' system of micro abrasive papers on a piece of 1/4" plate glass? From what I have read about it, the 3 micron paper is equivalent to a 4000 grit stone and the 1 micron is about a 8000+ stone. I think the benefits would be, besides cost for a new honer, a perfectly flat hone every time. If you drop it, then you are out a piece of plate and some sandpaper.

I would like to eventually get a good Norton 4000/8000 stone, but for now I am looking at this system. The one I found complete didn't have that fine of paper, but, I have found a source for the finer stuff. And, there are several glass shops around I can get glass through.

Thanks everyone. I found this site when looking for honing/stropping instructions.

Revs, welcome.

The scary sharp system may be fine for all I know. But it's not widely touted around here, and these guys are extensive students of every honing possibility.:)

There exist ideas that appeal to the newb because of their apparent simplicity, that don't satisfy in the long run.

The two most popular systems, both simple and affordable, are the Norton 4/8K followed by pastes or finishing stone; and the DMT 1200 for bevel creation, followed by Belgian blue and coticule.

Welcome!

I agree with dylandog. It does seem like a simple system, but I really don't see it being useful in the long term. I'm not sure how long the sheets would last, but you will undoubtable have to change/replace them. The easiest setup for you would just be the nortons. I started with a 220/1000 and 4000/8000 combo stones, and they've served me well. To be honest, the 220 isn't too useful, so you might be better off with the DMT 1200 (also as dylandog said......) and the norton 4000/8000. Plus the DMT will work as a lapper to flatten the norton.

Personally I wouldn't worry too much about a finer stone than 8000 at this point, I would just focus on practicing with what you have before moving on to finer hones.

I hope that helps and doesn't confuse you too much! Best of luck,

Dave

Welcome!

Wildtim has put together this 3M Micro Abrasive Film, A Usage Guide and Review
it's worth reading as it cover the usage of abrasive films and staright razor honing.

Just remember, the finer you make that fin, the shorter it's 'shaving life'.

Find the balance that gives you -

best shaves x shaving life of blade.

Well, being I have a fondness for a sharp knife, I guess the Nortons would be the best choice for a beginner. The only problem now is, can I get my Spyderco Salt I that sharp? lol.

I had read about the Scary Sharp system for sharpening my knives and when I found this forum, wondered about the uses of it for a straight razor. The papers would most likely be changed after every use to get maximum effectiveness out of them, at least for my taste.

Thanks for all the replies. They have given me the answer I was looking for.