3 Attachment(s)
Removed a frown...Now trouble!!!
Ok I have a 7/8 Hollow ground and I successfully remove the frown by honeing it out on a Norton 220 for a long time. I did put one layer of tape on the spine. I changed the tape and moved up to the 1k to set the bevel. But after a while of honeing, the bevel is coming up all screwed up. On the stamped side of the blade the bevel starts ok at the heal and tapers to nothing at about 3/4 of the way to the toe and is doing the exact opposite on the other side. I go back down to the 220 to try to correct the straightness of the blade for a while and then lapped the hones and placed the razor on it to check the edge for straightness and it was straight. So i go back to the 1k and do like 20 laps and its doing the same thing again. I have no idea what to do. Maybe the spine has terribly uneven hone wear? I hope this made sense, does anyone have any suggestions?
Tony B :banghead:
This is the razor b4 I removed frown