Dropped Razor, my worst nightmare!
Hello,
I dropped my dovo best quality 5/8 1/4 hollow a few months ago a now i'm having problems getting it honed. No chip but a bend. Very slight bend only in the toe, tried to show a picture but none would show the problem. Imagine holding the razor edge up pointing away from you the toe of the edge would bend unnoticeably to the left. i can only see it when i hone. The problem is when i hone: the outward curve side is easy to hone cause i just do a rolling but the other side about one cm behind the tip wont completely hone. Most of the difficulty is setting the bevel as i have a narrow coti that seems to get in. I tried laying my finger on the little "bulge" to see if i can get contact but doing that don't make a good edge.
Any suggestions? Can i bend it back? Can i hone it out? I'm sure somebody here had a similar problem, that could lend some experience.