brush stand on the CHEEEP

let's face it, it's a damn dirty recession we're in and most folks don't have the spare cash to buy frivolous fooforaw, so here is my humble contribution on how to get your brush dried properly without spending much cash at all

what we need

a scrap of wood sawn to your liking (I used a scrap peice of 1 by 1 3/4 cedar)
1/16 brass or nickel stock (if you repin razors you have some lying around)


basically just saw the wood to your liking, bend the wire just like so DO NOT anneal it, we need a little spring here

then drill a 1/16 hole in the wood and press fit it (glue it if you like, mine's snug enough without)

end pic is with a Kent hangin dry



Attachment 47611

Attachment 47612

Attachment 47613

IMO cheap is always a good move if you get the same results. Thanks for the pictorial.