Attachment 193561
Would this be considered an unacceptable amount of hone wear on a used vintage Kamisori?
Printable View
Attachment 193561
Would this be considered an unacceptable amount of hone wear on a used vintage Kamisori?
Acceptable, but it could be a long time of honing to get it right. I have a few that were worse. I would guess the flatter side is almost dead flat. That is where the honing, mostly takes place. And... that is where without great care, the honer will start a rocking motion and really screw things up. Low and slow does the trick.
gssixgun could comment better on condition and possibilities.
~Richard
PS. I do not hone for other folks. Too much to learn for my own goodies.
Really tuff call from the pic but I will try and tell ya what I look for
1. Is there a hollow grind still there on both sides of the razor ??? Kamisori are Asymmetrically ground but they still have hollows on both sides they are just un-equal.. No hollows No Buy
2. On the Stamped side the side we cannot see look at the top of the razor (Spine on a Western) how much wear is there.. How large is the bevel on that side, it should be TINY near invisible
3, The side we are looking at, the Un-stamped side, see how the wear is un-even ?? that is from a bad honer :(
4. The heel, on this pic it is hard to tell, but if there isn't an actual heel defined and distinct so that the edge is defined and distinct, I won't buy it..
Those are the 4 things I always look for, otherwise it is just a sharp chunk of steel :(
Attachment 193569
What about this in comparison?
Honestly both these pics are obviously done by the same person and both are at the exact worse angle to really judge the razor..
Are there other pics ????
Not of this side of the razor. maybe for a reason.
I just looked through his listings, Yes those of us that hunt Kamisori know exactly who's pics those are :p
There are several that are only about $30 more than the ones you have shown and some are in really nice condition..
There are a couple of Tosuke that if I were in buying mode I would snag in a heartbeat :D
Thanks a lot. I appreciate it.
Not uncommon for Japanese sellers, those wonky angles hide issues pretty well.Quote:
Originally Posted by gssixgun
@ OP
I'd ask the seller for better pics.
lack of knowledge and fear of getting a razor that is "not right" is the only thing keeping me from buying one !! just 2 scared to buy a used one and not ready to buy a new one ..lol
but this thread has gave me more info then I have found by previous searches !!
