Is this a Robeson?

Attachment 279113Attachment 279114Attachment 279115Attachment 279116Attachment 279117Attachment 279118Attachment 279119 Good evening. Question for the panel. Since I cut myself off from razor acquisition until I can set a bevel/hone and sharpen my own razors without fear of messing the edge up I figured I should probably get at least one test razor.. I found one😁.. This was in a local classified and described as Robeson Faux Frameback In good condition and shave ready. I took the bait as it was priced right and if it was a dud I can use as test razor for honing. I got it today and I can't find anywhere stamped Robeson. It has some etching on blade fronts but I can not make it out. As can be seen it was dropped with chip off front and chip in edge. It did come quite sharp so prepped to shave and had back up razor set to take over when this one scratched me with that edge. To my surprise this razor worked great and never felt that edge chip or the one on the tip. I only did one pass because I had as my back up a Crown/Sword that Mike ( M14shooter) had graciously reset bevel and sharpened for me and love how well it cuts now so did the last pass with that.. Anyone able to verify this as a Robeson? And since the nicks on this razor didn't seem to catch my face or neck in any way is it ok to leave and use it like this? Or will the friction of stropping chip that even more?... As always thanks for the help, Scott

Hi Scott
The chip need to be honed out .It is not a frame back.I do not think it is a Roberson.But hard to tell with out close inspection.

I’m not sure that I’ve seen a Robeson in that style for before. I can’t say that it’s not one for sure, but I don’t think it is. It’s not a faux frameback either. It’s a shoulderless blade with a traditional grind. As for the chip and the nick in the edge. If it’s shavinng comfortably, and it’s not scratching your strop, go for it. Of course you will want to address both issues eventually.

Could be a Torrey. Really not sure.

I recognize that handle and below is a picture of a Torrey with the same handle. Of course, that may be a common replacement handle.

Attachment 279127

Thanks for advice guys. And I think you might be right about being a Torrey. Expanding the top pick of blade I can make out an R and a J in the dark spot toward front of the blade.. thnx

Torreys are good razors .Very good fine grain steel .Can take and hold a very high grit edge ,

Thanks for replies fella's.. closing this one down. Btw, it is a Robeson, fine imprint on spine. I could barely see it.. Goodnight

I have a George Whostenholm & son 5/8" Hollow ground that has the same blade shape.I also have a Robeson somewhere but my Robedoesn't look like yours!. That said they are great razors!


Slawman