Printable View
I have this pipe razor, 9mm in width. I have quite a few of these type blades and I cant figure out what there deal is.
Are or were they used primarily for trimming?
How are you supposed to hone them, I would need to half the tape length ways to start with.
This one is German I'm guessing, although the writing on the reverse of the tang does not seem German to me.
Attachment 283203
Attachment 283204
I think the general consensus is that blades in the 3/8 size range were for trimming. I have seen German blades in that size marked as "wiener schaber" literal translation "Vienna scraper", I think. IIRC those blades were shoulder less.
Yes, if you wanted to hone one with tape you would have to half the tape. Even with a 4/8 razor in a heavier grind you might have to half the to hone.
Blades 4/8 and smaller are a pita to hone and strop.
Bob
I've had a bonafide 2/8 razor for 8 or 9 years. I've still never tried to hone it since it is so minty and I don't see a way to properly tape it.
I have one of those wiener schaber blades too.
No way would I let these near my Kanayama.
I think most of them are in great condition because no one ever uses them.
Good point!
I have honed a few 3/8 and a 2/8 razor absolute nightmare to hone the 2/8 and especially strop, I have this miniature razor I restored a while back, looks like a perfect scaled-down model and not a corn razor it's a 3/8 I set the bevel and honed that one up to a shave ready edge it's a pretty little thing.
Attachment 283256
Attachment 283257
I've always heard those called mustache trimmers.
The trick to stropping them is to use a bench strop.
I fixed a few razors that ended up tiny. A 2/8, 5/16 and now 2 3/8 razors. Ive honed them and shaved with them once just so i can say ive compleated the job. Wont be using them again but i can say i own 2/8 thru 8/8 and every thing in between.
As they say, "just because i can".
This one has a lovely tang.
Attachment 283367
Attachment 283368
I like the old repair to the scales on that one. It looks like someone replaced the tip with a tip off another. I bet there is a thin piece of metal inside that they peened to?
Before epoxy and super glueQuote:
Originally Posted by xiaotuzi
Well played Sir.Quote:
Originally Posted by xiaotuzi
You are correct :)
Here is my 2/8 next to my 8/8...
Attachment 283403
Like i said, i shaved with it once!
words fail meQuote:
Originally Posted by Gasman
