Hey guys whats you opinion on the replateing of De's?
Printable View
Hey guys whats you opinion on the replateing of De's?
replating a razor is fine, but if you are going to sell it let it be known that it is replated. I have a couple that i'd like to have replated also.
What does it cost to replate a DE? I have a DE that my Dad used that is in need of a replate. I don't use DEs, only straights so the only reason I'd consider it is because it used to be his.
Chris L
replating cost is going to vary by model (surface area) and where you choose to get it done.
If you want to get a DE replated nickel your best bet might be a local chrome plating shop. These shops have to plate their parts in nickel first so the chrome will adhere well. You may also want to disassemble the razor prior to taking it for plating. What razor were you looking to get done Chris?
Plating kits can be had here for the do-it-yourselfer.
only problem with the plug-n-plate kits is they can be tough to get good results. There are things they don't mention with those kits. Such as, if you are plating over an existing nickel surface you need to pickle the surface using battery acid or the new plate will flake off. By the time you buy a kit to do one razor it winds up being more expensive (time and money wise) than taking it to a chrome plating shop where they can basically throw it in with their existing work load easily.
I haven't tried it before, I know the thickness can vary too when you do plating depending on how it's done. Probably is best to leave it to the guys that know what they're doing :)
yes that is another good point, tank plating (more involved and expensive than brush plating) will form a more uniform plate on a piece. It's not impossible to get an even plating thickness with brush/wand plating it just takes more practice.
That was the longest piece of spam EVER. Why do people do stuff like that?:nono:
Edit: thanks for removing that spam mods!
Hi everyone. I just got myself a nice old GEM 1912 and I would like to have it replated. I do not want to do it myself, I prefer leaving this to people who have done this (successfully, of course) before. Any ideas where I could get it done in CONUS or in Europe? I have attached a few pics to show the extend of the work needed.
Thanks!
In restoring old H-D's I use these guys, Brown's Plating | No One Lays Down Chrome Like Us .The work is great and turn around is fast. I've asked them about doing a razor but their service is great so it might be worth asking them.
Replating shops usually won't start with a job under $40. You can find a well-plated Gem for under $20 no problem. I've taken a plate worn 1912 just like yours and taken all of the nickel off. The brass underneath shines up wonderfully.Quote:
Originally Posted by Smoothy
Thanks, that sounds like an interesting alternative. Can you tell me what you've used to take the nickel off, please?Quote:
Originally Posted by Basset
Simichrome polish applied to a cotton t-shirt wrapped around a sander (sans sandpaper).Quote:
Originally Posted by Smoothy
Quote:
Originally Posted by Smoothy
You might want to contact buddydog over at Badger & Blade. He replated a Gillette fat handle Tech for me that turned out great. Another possibility is: Reliable Electroplating Inc. Chartley, Mass (near Norton Mass) 508 222 0620 contact Dale Broadbent info@ReliableElectroplating.com
Good luck...
Nathan