How important is it to do an x-pattern on a pasted strop? If you're using a wide one, is it ok to just go straight down? Or heel leading?
Printable View
How important is it to do an x-pattern on a pasted strop? If you're using a wide one, is it ok to just go straight down? Or heel leading?
I always initially use an x-pattern on my pasted strop. It's probably not entirely neccessary, but, seeing as a strop surface probably isn't going to be as flat as a hone, I use it just to make sure the entire surface of the bevel is covered.
It also depends on the particular razor you're working on. If the edge has a smile to it, then an X-pattern is about the only way you're going to get the whole edge, since only one section will touch at any given time.
A razor with a straight edge is probably OK to go straight across, but an X-pattern wouldn't hurt.
Josh
A heel to toe rock will get you the same results. With that being said, I still prefer the x lol.
I stand corrected. It took me a minute to visualize that, but you're right. An X-pattern is probably easier to learn (and explain!).
Josh
I usually do it on the hones when establishing the initial bevel to give the edge a SLIGHTLY smiling profile, but I don't see why it couldn't be applied to abrasive pastes.