DPRK razor

Purchased this North Korean razor, it's a NOS, from the info I could find they are supposed to be very god shavers,.. the blade is very clean, with just a little of rust at the pivot jimps.. she scales are just 1 piece plastic (that I would like to .. change, but I guess they have to be there for a full package)

Attachment 144500

the blade is a bit of center (I think that as a forging mistake), sorry for a bad pic quality..


http://shrani.si/f/26/9h/aVohB8L/1/dprka-3.jpg


Any ideas about how would you address this issue... the scales are cheapy, soft plastic so am not sure how much they would take :)..

I think you should try to change the pin and keep the original scales. ;) By doing this you might be able to fix your problem. ;)

hey YGG, thanks for your answer... I was thinkiong of doing that (and will probably try it) but am a bit suspicious about succeeding due to:
- the main reason for the blade being off center is off-grinding (se last picture)
- those are one piece scales, so nothing can be done with an eg new wedge
- plastic is in my opinion fairly soft and might get damaged very easily

I don't think repinning is going to solve this problem. If you want to keep the scales, you can sand down the inside of one of the scales at the place where the tang goes when it's closed. So if the razor closes to the right, sand down the inside of the left scale. Mind the razor, it is easy to damage it when still inside the scales.

Personally, I would toss the scales and make new ones!

Personally, I think you should just keep everything as it is if the blade doesn't touch the scales. The scales and this defect are both a part of the razor's history. And actually, this not a common defect :)

sanding/getting more flex on 1 side might be a good idea,.. I was actually thinking of another possibility (not sure if possible at all), I was thinking of using it for Ern Ator rescaling as well .. the idea I had was 3d scanning / 3D printing new scales,.. am just not sure what kind of materials are out there and if they would enable the similar characteristics needed for scales..

the new scales are the usualy way of mine :D .. but than on the other hand the razor'd loose on the North Korean originality :D

Before I did any real work to it I would hone it up and ensure it is worthy of your time, energy, and $. If it won't hold an edge, it's not really worth anything...

These razors are good shavers, not exceptional but fine. They seem to be tempered properly so can keep an edge and shave comfortably for a while.

shooter,.. noted, great idea,.. I actually purchased one razor few weeks ago, new one, wanted to hoe it up and resell it for the same price to someone wanting to start with razors (strop and razor would be 30 euro) but I couldn't get it sharp no matter what I did.. I tried 3 times, from scratch and failed :( not sure that I will try again :D ... here is my post about that one .. http://straightrazorpalace.com/razor...dge-razor.html