Printable View
Hey y'all,
i am working on this blade I got the other day and I kind of need some advice. I wouldn't mind getting a good shine on her but I really want to keep the etchings. The problem is that the etching a fairly shallow and it also looks like someone took a couple of swipes at ot with 100 grit paper. left some pretty deep scratches. Any of y'all have any advice for me? Granted I am not opposed to leafing it the way it is. Also here are some pictures.
there was a thread a wile ago, i can't seem to find it now. The original post was about the use of Mothers or Maas polish in conjunction with synthetic steel wool. Essentially very high grit scotch brite. Use the polish of your choice and mind your fingers!
Yeh I had looked for anything on the topic but came up short.Quote:
Originally Posted by RezDog
I would use some diamond paste on a soft buffer then some Fabulustre.
Maybe this one, or the one it references? http://straightrazorpalace.com/works...sandpaper.htmlQuote:
Originally Posted by RezDog
Or maybe someone else wrote one, too.
Start as fine as you can but I think you may wind up going to something like 1000 grit and working back up if you want mirror. Work on the the far side first with each step and see what you do. Personally I would start with Semi Chrome polish maybe 2000k paper and stay off the etch as much as possible.
On the other hand I don't see all that much wrong with it (from the pics) and maybe a light polishing will make you happy.
I did read the 0000 steel wool post a while back and that sounds very light and promising also. I have 3 grits of wool but never use them :thinking:
For any etching, stamps, or engravings I'm trying to keep I full them in with clear nail polish. I use I very fine paint brush to minimize "going outside the lines". Then I start removing metal with a higher grit, say 300-400. After I'm done get the nail polish remover out and take it off. Please note you may need to apply polish, sand, apply, sand etc... As needed. Best of luck.
IMO, do not touch that blade with any buffers or dremels or abrasives, maybe some maas or semi chrome.
Is fantastic the way it is.
Yeh I am leaning towards leaving it the way it is..... I don't know... I might hit it a bit with some 0000 wool and some Maas. I just reall don't like the way the scratches look that were left by someone else.Quote:
Originally Posted by pixelfixed
I think there's more to lose than to gain here. I doubt the etch is more resilient than the scratches and W&Bs are rare and valuable enough to leave it as it is :)Quote:
Originally Posted by Bamasamson
Well you guys are awesome!!! So many terrific ideas to try but I went with some blue magic and 0000 steel wool. She looks almost brand new besides some spiderweb pitting, but I am not going to touch her again unless its with a whetstone.Attachment 150343Attachment 150344Attachment 150346
I can't help but say that patina and some age markings is just a character of the blade. Its life if you will. Something to read while you shave with it or show a buddy!
Ray
Well walleyeman, I wasn't worried about the patina or pitting. I could have dealt with that no problems, it was the deep sanding or grinding marks going along the blade.
