just kidding,
I bought this razor on ebay for the scales. any idea what I could do with the blade besides binning it.
Printable View
just kidding,
I bought this razor on ebay for the scales. any idea what I could do with the blade besides binning it.
Thats for shaving around your eyebrows I think. :)
Wow - I always wonder how these end up that way...:shrug: Where's your intestinal fortitude?? - hone it out! ;)
James.
grind it down, slap a straight handle on it and you got a nasty paring knife. ;)
Nice scales, they would go nice on any of the fancy schmancy Dovo blades....hmmmm schweeeet...
Yeah, grind her down and see if she shaves...she might shave really good...
You heard the old addage that ugly babes are better in bed than hotties...they have to work harder to and make the effort to keep a guy interested...
I got a henckel started out as a 3/4 with an ugly nick now she's a 5/8 and shaves fine...
Quote:
Originally Posted by heliguy
agreeQuote:
Originally Posted by Lancer
or... grind it down, add a straight handle and you've got a beautiful Dovo letter opener... beautiful Dovo parmesan cheese shaver... anything but throw it in the bin mate.
Greg Frazer
:) Any tips on to grind it down with a dremel or an angle grinder:) (that all I got)
other than that there is a machine shop in work.
So what would be the ideal way to go about this and the do it what with what you got way to go at it.
I'd go with the dremel the metal is bloody thin and will melt away from the disk/drum.
Do you have any of the paper thin abrasive cut-off wheels that usually come with the dremel? I would be inclined to use a straight edge as a guide and use one of these to slice the blade just above the chip.
Then you could probably use sanding disks and/or a sharpening stone to re-profile the leading edge.
Depending on what you're going to make out of the broken blade, be mindful not to let it get too hot during cutting or you may destroy the temper of the steel.
It's impossible to measure from a photo, but if you were really careful you might just be able to make a 3/8 or 2/8 razor out of that.
Obviously that would require a lot of thinning at the spine to achieve the thickness/width ratio to allow you to set a proper bevel.
Greg Frazer
no, it's because they think it's their last time doin' it :PQuote:
Originally Posted by tgparker
Nenad
Ok so I ground it down with the dremel making sure not to let it get hot.
how do I reset the bevel, I only have a norton 4k/8k it seems like it will take some time with that so maybe Sandpaper but what grit/grits
btw it came out at 19/32
from measurements and good old math, the bevel only has a 3 degree change 7 to 10 does that sound right
looks cool.. what did it finish up as 4/8 or was there more meat on the bone after you ground out the nick?
Quote:
Originally Posted by tgparker
it came out at 19/32 not sure what you mean by meat on the bone.
cool! :y
not quite 5/8 but a tad more than 4/8, I'll bet it will still shave fine!
All the best!
Tony
I my have a go at doing that to a 6/8 razor i have with a similar sized chip out of the blade
Not too shabby! Get some 1000 grit wet/dry paper, lay it on a very flat surface and draw circles with the blade until it's sharp. Tape the spine. I'd really recoment you buy a 220k 1000k Norton combo for the job.
X
better pic
Nice! And to think you were considering "binning" it! ";"
- Scott