Anyone Use this set-up?

I was reading through some threads today and read a few comments about mico-routers. Does anyone have any experience with this Dremel set-up?
A Dremel 355-01 Plunge router with a small edge rounding bit/

Dremel 335-01 Plunge Router Attachment - Power Rotary Tool Accessories - Amazon.com

And I guess my question is, how do you hold the scales in place in order to run the router around the edges?
Thank-you

This probably should have been posted in the workshop section.

Rather than take the tool to the scales,take the scales to the tool. IE using a router table greatly simplifies the process.

Attachment 231335

[QUOTE=Utopian;1612605]This probably should have been posted in the workshop section.[/QU
Sorry.

Wirm, thanks for the information.

Depends how much you are going to use it and what you are going to do with it.

For a few dollars more, $54 the Stewart McDonald all metal version is a much better precision tool.

Luthier sites have all kinds of adaptations and jigs for these, to improve precision, worth taking a look at.

Quote:

---

Originally Posted by Euclid440

Depends how much you are going to use it and what you are going to do with it.

For a few dollars more, $54 the Stewart McDonald all metal version is a much better precision tool.

Luthier sites have all kinds of adaptations and jigs for these, to improve precision, worth taking a look at.

---

Thank you! That is the way I will go. I've book marked their site.
Kindly

I get all of StewMacs Tech Tips in emails plus I subscribed to their Youtube channel. They always have some cool stuff.