MicroFasteners Help Please

I was looking at microfasteners.com and trying to figure out what to buy and what sizes to pin some newly scaled razors. Can anyone help me out as their site is not very user friendly and I'm not good at converting sizes.

Thanks,
Tom:confused:

I use FLAT WASHER #0

/Johan

http://straightrazorpalace.com/works...able-pins.html

Only difference is now I get 3/4" long screws.

For the screws, you want

HBB0012 100 0-80 x 3/4 $ 8.30
from this page.

For the nuts most people like the smaller ones:
HNBS0080 50 0-80 scale 3/32 .048 $ 7.20
from this page. Note that they are smaller than the ones just above them, and are the same size as the head on the screws.

For the washers, you also have two choices, smaller and larger. Most people seem to get the larger ones:

FWBW0 100 #0 wide .064 3/16 .017 $ 4.20
from this page.

Some people also like the nylon washers for inside the scales around the pivot hole:
FWN0 20 #0 $ 1.90
from this page.

one thing that you will not find when you look up the site is the wrenches to use. you can order them online as well, but you just need to add in the comment section what you want. they will charge you for them after checkout. i posted this information but it can never seem to be made into a sticky. i will try to find it for you, but if you search you should find it also.

vgod

Actualy the wrench needed are available online at micro-fasteners. You can find them under the 'Tools and Miscellaneous' Miniature Hex socket wrench - Item WR0