Printable View
I just bought this on eBay -
http://i603.photobucket.com/albums/t...rokenBoker.jpg
Any cautions on filing down that so-wounded edge? I've got a Dremel and stone bits, ice water and patience. Other suggestions for taking off that much metal?
Thanks in advance,
Kern
Wow, I think I would have passed on this one. Hope you got a smoking deal.
How about a fiber cut off wheel? With the thickness of the blade, probably wouldn't take long to cut through, and therefore making not too much heat.
If you are stuck using the stone wheels, try using them as a cut off wheel. Don't try and grind away the metal from the edge, just grind into the blade above the chip. Might work not bad.
Good luck.
Yer, that!Quote:
Originally Posted by dnjrboy
I'm not sure it's possible to bring that back to life, some one has probably tries something similar though.
Yup, me :DQuote:
Originally Posted by gregs656
I ground away about that much metal using a bench grinder.
The blade was in contact with the wheel for less than a second each time and was dipped in water immediately after each pass.
It took a long time, but I managed to do it without overheating the blade.
After that was done, I gave it a new bevel with a 1000 grit hone and it was ready for honing.
The razor is pretty narrow now, but it's certainly usable and looks pretty nice. It also had the effect of making a hollow ground blade into about a 1/4 hollow.
Ouch.
Not sure it will be usable no matter what you do.
Other than maybe cutting the bulk of the blade off, just on the heel side of the blade, and making a 1 inch long "cootchie" razor.:shrug:
I wonder how much affect that would have on the bevel.
Looks like there's around 2 inches of good blade at the end, wouldn't that be perfectly usable as a face shaver? Call it The Longshank Redemption.Quote:
Originally Posted by Fnord5
Attachment 24992
Scribe a line from heel to toe just above the "chip" and cut along the line at low to med rpm using a cut off bit on your dremel. Go slow and keep watch of any heat. Before you start, clamp the blade securely and wear safety glasses .... you don't know what will happen once you start. Best case is you will have something useable, worst case you are out some $$ and time but will have learned to stay away from bad ebay blades.
You have nothing to lose so have some fun with it.
cheers,
Rick
Tell ya what, Kern. When you're finished with that one and you find you really had a good time doing it and can't wait to try it again. Get in touch with me and I'll make you a real deal on about a half-dozen just like that. :w
Regards - Walt
Talk to me, Walt...
Rick, thanks - I appreciate the advice - 'specially because it jives with what I was thinking.Quote:
Originally Posted by rsrick
'-)
Would that the grinding goes as quickly as your 'shop of that picture, Raj.Quote:
Originally Posted by Rajagra
And, iick? WTF is a cootchie razor...
A cootchie razor is a straight razor that has been purposely shortened which is used by women to shave their cootchie. :pQuote:
Originally Posted by Kern
When I did my coochie razor I used a Dremel cut-off wheel in a variable speed drill. Took a long time but worked fine.
