Nicely done! What did you use for pins/washers? I take it this isn't your first re-scale.
I think I may have to give the Krylon a try for my next set...
Fred
Printable View
Nicely done! What did you use for pins/washers? I take it this isn't your first re-scale.
I think I may have to give the Krylon a try for my next set...
Fred
The washers come from http://www.microfasteners.com/catalo...cts/WASFWB.cfm The #0 is the dimpled washer, and the #0 wide is the spacer or bearing washer. The rod is 1/16" K&B brass from True Value or a hobby shop. You should heat the rod on the gas stove to red hot and quench in water.