Clarification for re-pinning
Just to be clear... Hoping to finish up a restoration in the next couple of days and want to be clear about the arrangement of washer and scales
Tell me if I'm correct or if there are suggestions
On wedge end:
Washer -> scale -> wedge -> scale -> washer
Peen both sides to dome rod and lock rod and washer together
On pivot end:
Washer -> scale -> wide washer (acting as a bearing) -> tang -> wide washer (acting as bearing) -> scale -> washer
Again - peening both sides to lock rod and washer together.
Is this assessment correct?
Is it necessary to dome the washers between the tang and scales, or are these not even necessary?
Thanks for the advice.