Printable View
Thanks Geezer. I might actually end up using an old washing machine motor and buying an arbor adapter from that website for $12. Now that is in my price range! However, a $45 buffer with the 20% coupon is only $35 and has two sides......dang. Now what? Buy one and make one??? haha. Then I'd be on my way to looking like Glen! :rofl2:
The arbors make a lot of sense. Makes for a quick change.
But, if the arbor is loose it may require a thin shim around the shaft. And, be sure that the screws holding the arbor are "TIGHT". I place a thin bit of popcan folded into the screw holes before inserting and tightening the arbor screws. The screws should be showing almost no threads. That sorta protects the threads on the shaft.
If you hear a buzz....shut off the switch and duck. The buzz may mean that the arbor is coming loose.
And, an apron and face mask is a given!! if you have never buffed before, You cannot believe the stripe which immediately forms from the floor to the ceiling and includes you! the first time you load a buff with compound!!!:gaah:
Do a "buffer wiki" search here on SRP for interesting ways of using one.
Here's what I've been using, It's variable speed, and I do have need for a grinder, so it's multi purpose. It's a 6 inch, with quick diconnects for the wheels, works well. I believe they make an 8 inch model as well.
I've since removed all the guards....
Also consider your needs, and what you plan on doing.
When you start using greaseless you'll wish you had a fleet of buffers and a herd of wheels... hang some newspaper or something behind, below, and above the buffer while you are loading compound, it makes a tremendous mess.Quote:
Originally Posted by medicevans
That's the one I have. I'm in the process of ordering tapered arbors. $11 each from the above source. Now I just need ten more wheels, and 4 more grades of greaseless---------. By the way, does anyone know of a source for inexpensive 1/2 hard felt to make our own wheels? Felt is really the way to go, but the wheels are around $25 each. I'm looking for a cheaper DIY solution.Quote:
Originally Posted by zib
While you are at HF..pick up the packs of 6 hard felt 2"diameter wheels. For much of the razor work, especially cleaning against the inside of the spine they are really good. That is where a long shaft and adapter are worth the effort. The surface speed will be lower and less apt to destroy the temper if you are not very careful. Still... watch the temperature of the blade!!!
Use a piece of steel or the back of an exacto knife blade to roughen the cutting surface a bit, while spinning on the buffer, before applying compound. That will center the buff/mop and make a surface the compound can attach and meld with. Using snadpaper may leave some bits of abrasive.
I have found four inch stitched buff in four packs cheaply ofn the 'bay. They are "hard" cutting buffs. Use a soft buff to polish.
Thanks, Geezer. I checked HF online, and they didn't show 2 inch felt wheels, but my experience is that is often true. This gives me an excuse to drive over there and check it out. Hope to meet you if Mike Blue does another razor event!