Ideas on how to remove a knot from a brush sans drill.

Any way to remove a knot without a drill or a dremel? I can use some ideas.

Just grab it as close to the base as possible with a pair of pliers and twist.

Sharp wood chisels. But without breaking up the glue first with a drill, it is quite tough. Wear work gloves!

Quote:

---

Originally Posted by HNSB

Just grab it as close to the base as possible with a pair of pliers and twist.

---

I can only imagine the nightmare that would be :p

I've done it on at least half a dozen vintage brushes. It's worked every time.

Quote:

---

Originally Posted by HNSB

Just grab it as close to the base as possible with a pair of pliers and twist.

---

+1 except I used a bench vise instead of pliers.

There you go, then. The only knot I have removed to date had been glued in with JB Weld. Pliers did nothing. With a vintage, I guess it must be different.

Vulfix does an incredible job with their brushes as the epoxy is as hard as a rock. This is going to take forever.

Quote:

---

Originally Posted by jdto

There you go, then. The only knot I have removed to date had been glued in with JB Weld. Pliers did nothing. With a vintage, I guess it must be different.

---

I've never attempted it with a new brush. It definitely could be different.

Lay the handle flat on a piece of wood, and split it lengthwise with a chisel.

I bought the vulfix just for the handle, so I'm afraid that isn't an option, lol

Quote:

---

Originally Posted by Bruno

Lay the handle flat on a piece of wood, and split it lengthwise with a chisel.

---