I'd completely leave it the way it is. Often the trip to "perfect" ends up being the road to ruin. It looks great.
Printable View
I'd completely leave it the way it is. Often the trip to "perfect" ends up being the road to ruin. It looks great.
Looks great :rock:
I've had success sanding out really deep pits on the face of razors using a piece of dowel wrapped in sandpaper. If you sand lengthwise with a course grit you can bring out good steel relatively quickly. The dowel prevents the paper from going in and out of the pits and ripples. It's easy then to just move up the grits with or without the dowel. It's an awesome razor as is though!!
I think it looks great as is! Just leave it and enjoy.
I ended up getting some little hard rubber wedges designed specifically for hand-sanding different shapes of wood. I didn't eliminate the pits on the surface -- partly because I was paranoid about changing the blade profile, some of those pits were DEEP -- but I did make it a whole lot shinier.
I'd done a bunch more work on this one and its cousin, documented over here, but I am apparently constitutionally incapable of leaving well enough alone. I hated the 'brushed' finish on the scales so I took it apart and sanded them some more. Then I figured while I had it all disassembled again I might as well try for a better finish on the blade. Much hand-sanding later, and three days in the vibratory tumbler, and I got this:
Attachment 95030
Attachment 95031
Attachment 95032
Attachment 95033
Attachment 95034
very nice, and much better !
Now we're talking! ;)
Well done!
Looks great.