No, it wont work. Not at that speed and a frequency drive to slow it down would cost 10x more than an inexpensive 800-1200rpm buffer. At that speed, you are likely to take off a finger or worse if the blade catches on the wheel.
Printable View
No, it wont work. Not at that speed and a frequency drive to slow it down would cost 10x more than an inexpensive 800-1200rpm buffer. At that speed, you are likely to take off a finger or worse if the blade catches on the wheel.
how about a way to slow it down permanently say 1500-2000 and from there start using larger or smaller wheels.
Why not just use step pulleys and a cheap shaft & bearing set up?
Gary
sorry i am not a native speaker. a picture or image will help.