While setting a bevel on a new to me razor, I've notice through use of the marker test that two 1-2mm sections on one side is only slightly touching the hone. The other side has a nice even bevel along it's entire length, as does the troubled side except for these two small sections?

I've tried a gentle C shaped heel to toe carve motion with a narrow hone in order to contact the entire blade on that side with not luck. Yes the razor has a nice smile. The entire length of the razor from 1200-4000K will shave forearm hair, but under microscope and with the naked eye you can see the bevel dip in those to spots with marker to a very fine bevel line. Should I leave well enough alone or grind it out so to speak for those two spots.

Kind regards,