HI I was wondering I have a little nick in my blade so I'm using a rough stone to set the bevel again. It's probably somewhere around 1000 grit. I was wondering if I should go to another stone before I go to the 4k side of the norton. I also have the col. conk stone which I have heard some say is around 2500 to 3000 grit. Would that be better to go there before the 4k. I was also wondering if I went from the 1000 to the 4k side of the norton if it wouldn't do much because you are going to too high of a grit too soon after the 1000 so it wouldn't do too much. Any help?