Results 1 to 9 of 9
Hybrid View
-
12-27-2010, 05:50 AM #1
- Join Date
- Dec 2010
- Posts
- 2
Thanked: 0Beggining with my first Straight Razor
So for Christmas I got my first straight razor set-up! Includes: Professionally honed 6/8 full-hollow Dovo straight razor, badger hair brush, mug and shaving soap, and a beginner’s strop. For my first shave I just tried WTG and that turned out fine, only a pin prick size cut for when I was sizing up my neck. Today went through and tried a across and against the grain and got about two nicks and a tiny slash, haha.
Any tips for holding the razor? Do you switch hands or do you stay with one. What are good ways to make sure you get a close shave, I had a bit of a hard time along my jaw line and close to my ears?
Any other tips would be appreciated!
-
12-27-2010, 06:39 AM #2
Best suggestions I could give you is go slow and use very light pressure. Also do not worry about BBS shaves at this time. Here is a good thread read the PDF in the first post lots of good advice in here .
-
12-27-2010, 11:44 PM #3
Check out the wiki. There is a ton of info on stropping, beard prep, and of course how to actually use a straight razor.
The 3 most important things to focus on in the beginning is keeping the pressure really light, keeping the angle at 30 degrees or lower, and getting good skin stretching.
Any tips for holding the razor?
Do you switch hands or do you stay with one.
What are good ways to make sure you get a close shave, I had a bit of a hard time along my jaw line and close to my ears?
The jaw and chin are some of the hardest parts to shave. Using small buffing strokes and frequent repositioning of the skin stretching hand help. Most of all, you just have to be patient and accept that parts of the shave will be sub par until your technique develops.
Any other tips would be appreciated!Last edited by markevens; 12-27-2010 at 11:53 PM.
-
12-27-2010, 11:51 PM #4
Practice, practice, and more practice.
-
12-28-2010, 01:24 AM #5
About ears
My ears are sculpted by the best of Soligen and Geneva
One member had issues with vision, and I supported him to touch down w/ the blade 1/2-1" from the ear. Short, light buffing strokes as you proceed closer to the ear. At this point, seeing the point may or may not be possible, so I suggested switching attention from the visual to the tactile (feel). The short, buffing strokes with no pressure will allow you to feel the point get closer to the ear contours. When you feel the point running into the rise in the skin that's adjacent the ear, you'll know you're there & not to go further. The short light stroke there can keep you from some carnage.
I'm no expert, but I clear the area next to the ear first - no unlike someone painting a room where you 'cut in' - by doing the fine detail with a brush, and when that's taken care of, the bold strokes of a roller can finish the wall with confidence.
-
12-28-2010, 05:16 AM #6
I, too, am new here, having only been around about 6 weeks. I'm doing my entire shave with my dominant hand as I'd rather get my technique down before I train my other hand. Something I found useful was to let my beard grow for a few days, that way, I could get a really good idea of the growth patterns. You'll be surprised at the odd angles your beard grows. What you think is WTG may actually be XTG, and so on. In any event, welcome aboard!