Printable View
Not done, but here is my first resto attempt. It is an old Rodgers and Son. It had horn scales, but they were broken. I am using oak, cause it is the most readily available to me. The blade had severe rusting, I took off as much as I could without regrinding the whole thing.
Most of the blade resto was done by hand. The scales I did with a 'Dremel'.
It is not perfect but I learned alot.
Now to finish the scales.
Attachment 48959
Attachment 48960
Attachment 48961
Attachment 48962
You are learning well! A guy once't told me that giving your best shot is important. You didn't go all out and remove all of the history from the blade. When you finish the scales, you will have a nice looking razor. Take a look at some of the wedges shown in other restorations, that tapered wedge will reduce the bulk of the scales. Remember to finish the inside of the scales! that will keep them from warping. Washers inside on the pins are important with that heavy blade.
You are doing very well!
~Richard
I personally prefer a blade that shows it's history a bit. Some hand sanding on those scales to smooth them out a but and you are golden. Congrats
Yes, the sanding of the scales is the next.
As far as the wedge, I have considered sanding it thinner, but this blade is a monster.
I'll make another and taper it to see what it's like. The blade sits nicely at the width it currently is.
I will be finish sanding the whole thing, inside and out, and finishing with tung oil, as recommended by another member.
Congrats on your first.
Don't believe a large blade requires a fat spacer. Most of those wedges sit fairly high in the scales with the Barber's notch somewhat exposed. Look at the original. It is likely a fairly slim but tapered pewter wedge.
Congrats. Show us the scales after sanding, please.
Nice job. What kind of time did you put into the blade?
Not sure exactly, I am doing most of the resto by hand. Didn't have all the right grits at first, sothe time was split up. If I had to guess I would say about 3-4 hours.
About the same with the scales. This is my first time, so everything is stop and go. I also don't have fancy tools. I am sanding by hand, cutting with a coping saw, and shaping with a 'Dremel'.
It sure is fun though.
I put together some unique tools to help my effort. O ne for shaping the wedge I thought was genius, I'll have to post a pic sometime.
I did finish the sanding today, just haven't taken the pics yet.
Thanks for the feedback.
