6/8 W&B Regrind in Epoxy coated Zebra wood scales.

Printable View

03-31-2013, 10:10 PM
ironsidegnr

8 Attachment(s)

6/8 W&B Regrind in Epoxy coated Zebra wood scales.

Well, thanks to NinjaMaster (SRP Member) I finally got to try my hand at regrinding a few blades.

Here is the first one that I have totally finished.

Before I went at it with the tools, it had a BIG crack/chip on the toe.
I had to remove about 3/32 from the end of the blade.

Interestingly enough, it was just enough to make the point nice and square again!

Oh yeah, scales are zebra wood with a gree/black acetate wedge. Pins and hardware are all brass.

Cheers!

Attachment 126033 Attachment 126034 Attachment 126035 Attachment 126036 Attachment 126037 Attachment 126038 Attachment 126039 Attachment 126040
03-31-2013, 10:18 PM
Chevhead

Looks really NICE.
GOOD JOB!
03-31-2013, 10:35 PM
Catrentshaving

What part did you regrind?

Edit: Ah nevermind, I read again and you shortened the toe. I thought you meant reground as in revamped the entire blade.
03-31-2013, 10:36 PM
Iasonas

Great work on the regrinding, the scales also look awesome!!!
03-31-2013, 11:09 PM
ironsidegnr

I actually did regrind the whole blade. Just enough to even out the old hone wear.

It must have worked right, because the bevel is straight as an arrow now!
03-31-2013, 11:25 PM
lz6

You did a great job with that.
04-01-2013, 01:02 AM
TwistedOak

that point scares me, but nice work :dropjaw:
04-01-2013, 01:09 AM
regularjoe

Way better than my first attempt. Congrats! So now we need details. What size wheel, grinder specs, etc. :)
04-01-2013, 03:25 AM
Catrentshaving

Quote:

Originally Posted by ironsidegnr

I actually did regrind the whole blade. Just enough to even out the old hone wear.

It must have worked right, because the bevel is straight as an arrow now!

Can you explain? If you reground the blade then why the remaining pitting?
04-01-2013, 10:32 AM
ironsidegnr

Sorry guys, let me clarify.

I reground the entire toe to remove a huge crack/chip make it square again.

I then used the unsupported section of a 1'' bench sander to re-work the spine and tang.
which allowed some 'flex' in the belt to get some of the rounder spots.

I didn't have wheels to get into the hollows of the blade.

Honestly, I think it may have been too hollow to do that to anyways.

The hollows in the blade were hand sanded to remove the majority of the rust that's all.

I wish I had taked 'before' pics. This thing was in terrible condition. The whole blade was
very black with lots of deep old corrosion.

I'm still researching wheels speeds etc. Gotta figure out how to make a useable wheel
for my sander so that I can work on hollows.

Hope this clarifies everything.

Thanks for all the interest!