3 Attachment(s)
Input, Comments on Razor build
I am fairly new to this forum and like to mostly read about what the world of Straight Razors and current events regarding the such. I have for just a little while now have been making razor. I have been using mostly 01 just because of the economical factor the the fact that I went into it knowing that there was going to be just a small (sarcastic) learning curve. After working preforming restorations and scale fabrication for sometime now and really studying the geometry of razor I just had to try to make one. I also have been ready a lot but nothing in my opinion is as important as comments and feedback from others. I am posting a razor that I just finished. It was fabricated from Damascus steel (1095 & 15N20). It is 11/16 with a Spanish point laid in red horn scales. It really shaves nice and holds its edge well. I have found that the area in which I have to most problem in making a straight razor is the heel, particularly keeping it even. I am open to any feedback that is available about methods that could help with this or any input or advice for that matter!. Thanks!!Attachment 210434Attachment 210435Attachment 210436