RSO #2 & a Cherry popper knife

G’day all,
finally got my grinder finished off, painted (if I could call it that), back together and up and running last week.
So ground up a straight & I got to pop my knife making cherry on the weekend as well and came up with these

Attachment 212984 Attachment 212985
Attachment 212986 Attachment 212987
Attachment 212988 Attachment 212989
Attachment 212990 Attachment 212991
Attachment 212992

Went free hand stock removal, used my tool rest for support only

Both the Str8 & blade are from 1095 30*5mm flat bar

The str8 is 3/4” with a ¾ hollow grind I think

Rough ground to 120 grit leaving about 1.5mm on the blade edge

Annealed & Heat treated in my mini gas forge with Thermocouple
800° then into 70° Canola oil (got a nice loose carbon coating)
Tempered at 230° for 2 x 1 hours cycles in the oven

Post HT Final ground from 120 to 1500 grit & to about 3 thou at the edge
Then bevel set on the Nani SS 1k using no tape to check for high points etc then some final edge clean up

Not completely happy with the final outcome as the grind kept growing at the tang & got to close to the pivot for what I wanted.

So only made some quick acrylic scales for it.
So now awaiting a full honing then when I do some other blades waiting to get touched up, then the shave test can follow;

The knife is about 240mm over all with Burdekin Plum scales with brass 3mm pins & fillets quite well now

Thanks for looking
Dion