Hi all, looking for some genuine feedback on a razor I started today.
No need to be nice, I'd like it to be functional.

I have a feeling I need to move the plunge back, perhaps 3-5mm and I'm
going to take some material out of the tail so the curve is in the top at the back.

Once I've heat treated I'm going to take the grind higher on a 10" wheel and then do a secondary bevel with a 5" wheel to get a double plunge (not sure what it's called) and a nice fine edge.

This will be the first razor I've finished. I've started a couple a few years ago but got distracted.

This was forged, normalized, surface ground and the bevels rough ground this arvo, so I'm a bit faster than I used to be. Hope to have it heat treated and ground by the end of the week. It's a piece of Damascus I previously forged. I plan to do the scales in an Aussie hardwood.

Any and all comments welcomed.

Thanks,

Matt