Was the stone lapped and beveled?

Are you taping the spine and do you have some magnification?

Are you able to cut the same hair with a double edge razor blade?

Mark the bevel with sharpie ink and do one lap, then look at the bevel and see if you are honing to the edge.

When those razors are honed at the factory they are honed with the spine off the stone to not bugger up the spine. So the bevel angle will not be the same as honing with the spine on a stone.

First you have to set the bevel, get the bevels flat and in the correct plane from spine to edge, and get them to meet at the edge.

Here is a good recent honing thread with great photos of the entire honing process from start to finish by a new honer.

Second try at Honing