Results 1 to 10 of 17
Thread: Honing a wedge with no shoulders
Threaded View
-
10-23-2013, 08:36 PM #1
Honing a wedge with no shoulders
I got a custom from a guy, not very expensive, but made from some nice d2 with a good heat treat.
The problem is, it has no shoulders, its prettly much a true wedge/flat grind.
Hes pretty amateur at making straights, he mostly does fixed blade knifes. (this is kind of a side project to use up some scrap)
I like the design over all, but I'm not sure how to approach honing it sense i cant rest the spine on the stone while honing the edge.
Should i just tape to the proper angle? (also what is the proper angle??)
Thanks
-Daekkon