Thread: Diamond Spray Then Crox?

Must one always go to a Crox after he touches up with a diamond spray? In other words, can you go to straight to canvas/ leather after diamond spray with not using Crox?

The only rule is the rule oh yo face .

Hence, if you face says its ok - its OK.

What mil diamond spray you using?

Do not get fixated on sprays and pastes,JMO

Originally Posted by pixelfixed

Do not get fixated on sprays and pastes,JMO

Not even for touchups?

Originally Posted by ELDivo

Not even for touchups?

To a point they can refresh an edge,but the time will come when they need to see at least a finishing stone,than a little crox,in my case a 12k shapton,20/30 strokes max on water,than 10 on Crox,blade is good for another 6 mos.

.50 Diamonds is different shaped abrasive than .50 Chrome Oxide.

.50 Diamond, will refresh an edge quickly, start with 6-10 laps on the diamond and test.

What you have the Diamond on, will also affect the diamonds ability to cut.

Softer substrate, like paper, felt and foam will be less aggressive than wood, balsa or leather, experiment. Paste can keep an edge going for a long time, perhaps indefinitely.

Some folks do not like paste, it is a choice. But there is no question that they work and have been working for over a hundred years now.

Yea…Depends on the Diamond Spray grit size and number of laps.

If it is too low, of a grit and/or you do too many laps it may be harsh. I think people tend to use too much pressure and do too many laps with diamond, it will cut fast.

So as said, if it feels harsh, some Chrome Oxide will smooth it out. So might linen or just plain leather. It depends, Chrome Oxide is usually a “go to.”

I like a .25 Diamond and .125 CBN as a good maintenance combo.

Originally Posted by earcutter

The only rule is the rule oh yo face .

Hence, if you face says its ok - its OK.

What mil diamond spray you using?

.5 the Crox is .5 to so isnt it overkill?