Results 1 to 7 of 7

Hybrid View

  1. #1
    Junior Member
    Join Date
    Apr 2006
    Posts
    25
    Thanked: 1

    Default 1/4 ground wacker spike point...

    howdy fellas,

    i bought two 1/4 ground wackers from john crowley a month or so ago. a spanish point and a spike point. anyway, i'm having trouble sharpening the spike point. after some experimentation, i've found that the spanish point honed well when on a 30+ degree angle on the hone (point to shoulder) and then honed on an angled motion (shoulder to point).

    but with the spike point, i've had no luck with any of the honing motions. i've tried the same motion as mentioned above, an angled-orientation on the hone but a straight push; a 90-degree orientation on the hone with an angled push; even a 90-degree orientaion with a straight push. but no matter what i do, the razor won't sharpen well enough to pass the hht. and over the past few days, i've honed 14 razors. all but the spike point are good and sharp.

    i'll admit that my technique isn't the best, but still i'd appreciate any advice you can offer. my honing system is to work the pyramid on the norton until i can pass the hht. and then move on to the coticule so that i can slice hairs of any length with the least amount of pressure. again, any advice would be greatly appreciated.

    cheers,
    jake pollock
    taipei, taiwan

  2. #2
    Loudmouth FiReSTaRT's Avatar
    Join Date
    Jun 2005
    Location
    Etobicoke, ON
    Posts
    7,171
    Thanked: 64

    Default

    I'd do about 30 strokes on the 4k, 10 strokes on the 8k, lap the hone and do an aggressive pyramid.

  3. #3
    Electric Razor Aficionado
    Join Date
    Apr 2006
    Posts
    3,396
    Thanked: 346

    Default

    If you've got access to a microscope with at least 60x, check the edge for microchips. Wackers are very hard and sometimes can be a bit brittle, and this makes them prone to microchips unless babied on the hone. It can also make them very slow to hone...

  4. #4
      Lynn's Avatar
    Join Date
    May 2005
    Location
    St. Louis, Missouri, United States
    Posts
    8,454
    Thanked: 4942
    Blog Entries
    2

    Default

    You may want to do a few strokes on the razor close to the spike and then do full strokes to blend into the rest of the edge.

    Good luck.

    Lynn

  5. #5
    Member
    Join Date
    Jan 2007
    Location
    Austin, TX
    Posts
    40
    Thanked: 0

    Default

    good luck and please report back if you figure it out. I have the same blade I have been fighting with for a while.

  6. #6
    Senior Member blabbermouth jnich67's Avatar
    Join Date
    Jun 2006
    Location
    Westchester NY
    Posts
    2,485
    Thanked: 184

    Default

    Keep in mind that I'm no hone master... It took me a really long time to get my 1/4 Wacker shave ready- ultimately hundreds of strokes on the 4K-8K. I'd go with Firestart's and Lynn's advice and test frequently. I found it to be a very nice shaver once I got it in the zone. Good luck!

    Jordan

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •